If it does not, reapply the setting to your NIC, and be sure to hit OK to close the Properties box and register the setting. Go to Tools > Options > Network to verify this value matches the static address you assigned for IPv4 on your NIC. There should be no other devices on the network with the same IP addresses that you are using - if there are then you must change them so that every device has a unique IP address.įinally, you need to make sure that you have the Audia or Nexia software configured to see the correct NIC (Network Interface Controller) and confirm that it shows the IP address you expect. If you give your PC the same subnet address as the Biamp device (by setting the PC to match the device at 192.168.1.101) you will not be able to communicate with it.

If the device returns an address of 192.168.1.101 you can make your PC address 192.168.1.100 and communicate with it.

Note: Be sure you do not set your PC’s address to the same address as the device. You can now change your computer's NIC (IPv4 address) to match the subnet range for the Biamp device and connect to the device using the Audia or Nexia software (as appropriate).

Apply wireshark ip to http